Hoover S3755 Manual - Page 9
Agitator brush roll, replacement, Headlight replace, Edge groomer, Lubrication, Thermal protector - belt
UPC - 073502025260
View all Hoover S3755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3-16 Agitator brush roll replacement When to replace Disconnect cleaner from electrical outlet. When agitator brush roll brushes are worn, the brush roll should be replaced. To check condition of brushes, move edge of a card across bottom plate while turning brush roll. To maintain cleaning effectiveness, replace brush roll if brushes do not touch card. What to buy When purchasing a new agitator brush roll, ask for HOOVER part no. 48414071. How to replace Disconnect cleaner from electrical outlet. 1. Remove hood, duct cover, belt and brush roll as shown in Figs. 3-8 to 3-13. 2. Discard old brush roll. 3. Replace new brush roll and belt as shown in Figs. 3-13 to 3-15. Headlight replace- ment The headlight, located on top of the power nozzle, operates when the cleaner is turned on. Use only HOOVER part no. 27317307, which is a fused bulb, when replacing the headlight. How to replace Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands. 1. Remove the hood as shown in Figs. 3-8 and 3-9. 3-17 2. Push old bulb into socket and twist to remove. Push new bulb into socket and twist into place. 3. Replace hood. Thermal protector An internal thermal protector has been used in your cleaner to prevent overheating if a large item or clog gets caught in the nozzle or at the opening of the bag. When the blockage is not removed, the thermal protector will trip and the cleaner will stop running. If this happens, turn cleaner OFF and disconnect cleaner from electrical outlet. Then disconnect nozzle and remove obstruction. Within 15 minutes, the thermal protector will cool and automatically reset and cleaning may resume. If cleaner does not operate, allow additional time for thermal protector to reset. Edge groomer replacement When to replace The edge groomers, located on both sides of the nozzle, should be replaced when they no longer extend past the surface of the bottom plate. What to buy When purchasing edge groomers, ask for Hoover part no. 39511004. How to replace Disconnect cleaner from electrical outlet. 1. Remove hood and brush roll cover as shown in Figs. 3-8 to 3-10. 3-18 L K 2. Pull off both old edge groomers (K). 3.Push each new groomer onto the 3 tabs (L), starting with one of the end tabs. Then push the groomer onto the middle and remaining end tab. 4. Replace brush roll cover and hood as shown in Figs. 3-14 and 3-15. Lubrication The motor is equipped with two bearings that contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. The agitator brush roll is equipped with two ball bearings that should be lubricated periodically by a Hoover Sales and Service Center or an authorized Hoover Warranty Service Dealer (Depot). 9