Hoover S3865 Manual - Page 9

HOW TO OPERATE 4. HOW TO OPERATE NOTE: Operate cleaner only at voltage specified on the data plate on the underside of the cleaner. 4.3 Vacuum Controls Handle/Hose Grip 1 1 Power Button Push to turn cleaner on and off. 2 Brushroll On/Off Button Push to turn Brushroll on and off. 3 Suction Control Valve To clean delicate fabrics, slide the Suction 2 Control Valve to the open position to lower the suction. Slide as shown to open and close the Valve. CLOSED - OPEN 4.4 7 3 Indicator Light FLOOR SELECTION Very High Pile Carpets. Low to Mid Pile Carpets. Bare Floors. (Brushroll off) 4 5 6 Nozzle 4 Floor Selector Pedal Push the Floor Selector Pedal to raise and lower the Nozzle to clean bare floors and various carpet pile heights. For maximum cleaning performance, the following carpet height settings are recommended: • Low and Medium settings: for low to medium pile carpets. • High setting: for very deep pile carpet where easier pushing effort is desired,while maintaining good cleaning performance. NOTE: If the cleaner is difficult to push, change floor selector push button to the next highest setting. NOTE: In Bare Floor mode brushroll will automatically shut off. 5 Floor Selector Indicator Light Indicates the carpet height selected by the Floor Selector Pedal. 6 Handle Release Pedal Step on the Handle Release Pedal to lower hand grip into cleaning position. NOTE: Brushroll will not run until handle is released. 7 Reset Button This power nozzle is equipped with an electrical reset button. If the brushroll is jammed, the rest button will automatically shut off the brushroll motor. If this happens, unplug cleaner and clear jam from brushroll. Press the reset button, plug in the cleaner and resume use. 9