Hoover UH70600RM Product Manual - Page 12
Brushroll
View all Hoover UH70600RM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Carbon Filter : How to Clean (Available on select models only). Your Carbon Filter is located on the underside of the Filter made with HEPA media. IMPORTANT DO NOT RINSE OR WASH the Carbon Filter. What to Buy: Carbon Filter Carbon Filter may need to be replaced more often to maintain optimal odor absorbing effectiveness. Additional filter is available at Hoover.com or call 1-800-944-9200. Ask for Hoover® Part No. 902404001. Cyclonic Filter Assembly: How to Clean 4.9 ! CAUTION ! To reduce the risk of personal injury - unplug vacuum before servicing. Do not use vacuum without dirt cup or filters in place. A 4.10 Remove dirt cup as described in Fig. 4.3. 4.9 Twist filter assembly (A) counter-clockwise. Remove assembly from dirt cup. 4.10 Dirt and debris can be cleaned from the filter assembly with the Dusting/ Upholstery Tool. 4.11 If further cleaning of the internal filter assembly is required, turn dust skirt (B) counterclockwise to remove. 4.12 Grab dirt cup shroud (C), pull straight off and clean with dusting/upholstery tool. After cleaning, replace dirt cup shroud (C) onto and inside edge of filter assembly and align center lines with Hoover® emblem. Place skirt (B) onto shroud, align (4) slots with (4) tabs, and turn clockwise to lock. Place the filter assembly (4.9, A) on the dirt cup, aligning (3) tabs on filter with (3) slots on dirt cup (B) and twist it clockwise to secure into position. BRUSHROLL: How to Clean ! CAUTION ! To reduce the risk of personal injury from moving parts, unplug vacuum before servicing. 4.11 4.12 C B The Hoover® emblem and center lines on the dirt cup should all align on the front of the dirt cup if assembled correctly. Replace dirt cup as described in Fig. 4.5. 4.13 A 4.14 B 4.13 Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counterclockwise. 4.14 Slide (2) lower latches (B) to the unlock position. 4.15 Pivot out bottom plate and remove any debris and/or hair from brushroll. 4.16 Reposition bottom plate, aligning (2) screws on nozzle with lower latches (4.14,B). Press firmly on all front edges (4.16) of nozzle guard to ensure that it is properly seated. Slide (2) lower latches to lock in position, and rotate red upper latch clockwise. 4.15 4.16 Actual model may vary from images shown. 12