Hoover UH70600RM Product Manual - Page 14

Belt ! CAUTION ! To reduce the risk of personal injury from moving parts, unplug vacuum before servicing. The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. When To Replace Replace belt if it is stretched, cut or broken. To check the belt, refer to Fig. 4.24 - 4.26. How To Replace 4.24 Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counter clockwise. 4.25 Slide 2 lower latches (B) to the unlock position. 4.26 Lift off bottom plate. 4.27 Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard. What to Buy: Belt Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt for models with Brushroll On/Off (Suction Only Mode), ask for Flat Belt - HOOVER® part No. 562289001 or AH20065. If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200 4.24 4.26 4.28 A E F 4.25 B 4.27 DC 4.29 4.28 With lettering on outside of belt, slide new belt over motor shaft (metal rod) (E). Then slip other end of belt around area of brushroll without bristles (F). With belt in place, pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation. 4.29 Reposition bottom plate, aligning (2) screws on nozzle with lower latches (4.25,B). Press firmly on all front edges (4.29) of nozzle guard to ensure that it is properly seated. Slide (2) lower latches to lock in position, and rotate red upper latch clockwise. IMPORTANT Rotate brushroll manually to make sure belt is not twisted. Actual model may vary from images shown. 14