Hoveround MPV5 User Manual - Page 42

Optional Legrests or Footrests - elevating leg rests

Get Hoveround MPV5 PDF manuals and user guides View all Hoveround MPV5 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

Hoveround-MPV5ManualRevM 1/17/14 10:37 AM Page 42 Optional Legrests or Footrests 1. Install each leg/footrest on to the appropriate hanger bracket and swing into the forward facing position. If elevating legrests are installed, set the angle to the lowest possible position. 2. Fold down the foot plates. Your feet should comfortably rest on the plates without a tendency to lift your thighs from the seat cushion. 3. If length adjustment is necessary, loosen the bolt at the base of one of the footrest stems by two complete turns, (1/2 inch wrench required). Tap the head of the bolt to loosen the inner tube from the outer tube (See Figure 5B below). 4. Slide the lower (inner) tube within the upper (outer) tube to achieve the correct footrest length. Tighten the bolt. 5. Repeat (3) and (4) for other footrest. 42 Chapter 5 Figure 5B D82008753M 10/13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
42
Chapter 5
D82008753M
10/13
Optional Legrests or Footrests
1.
Install each leg/footrest on to the appropriate hanger bracket
and swing into the forward facing position. If elevating legrests
are installed, set the angle to the lowest possible position.
2.
Fold down the foot plates. Your feet should comfortably rest
on the plates without a tendency to lift your thighs from the
seat cushion.
3.
If length adjustment is necessary, loosen the bolt at the base
of one of the footrest stems by two complete turns, (1/2 inch
wrench required).
Tap the head of the bolt to loosen the inner
tube from the outer tube (See Figure 5B below).
4.
Slide the lower (inner) tube within the upper (outer) tube to
achieve the correct footrest length. Tighten the bolt.
5.
Repeat (3) and (4) for other footrest.
Figure 5B
Hoveround-MPV5ManualRevM
1/17/14
10:37 AM
Page 42