Hunter 23298 Owner's Manual - Page 13
Setting the Dip Switches - remote control
View all Hunter 23298 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
8 • Assembling the Remote Control and Mounting the Cradle (Continued) Setting the Dip Switches You will only have to change the dip switch settings in the remote if you are using more than one remote controlled fan in the same area and want to control them separately. You may want to label your remotes to ensure you do not mix them up. 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change. Do not turn the power off at the circuit breaker for the previously installed fan, as you may inadvertently change the dip switch code settings for it as well. 2. Slide the cover off the back of the remote and remove the battery. The battery must be removed when changing dip switch settings. Refer to Step 8-1. 3. Change the dip switch settings, so that they are different from the previously installed fan. 4. Replace the battery and cover. 5. At the circuit breaker or fuse box, turn the power back on for the fan whose settings you are changing. 6. Within 20 seconds of restoring power, push the 3 (high), 2 (medium), and 1 (low) buttons (in that order) on the remote. Note: The receiver (built into the fan) has a memory function that retains the last dip switch code setting. The setting will not change in the event of power failure or if the power to the fan is inadvertently shut off. 2 1 0 Dip Switches Set to 01110 Dip Switches Set to 01001 3 13 41874-01 • 08/13/09 • Hunter Fan Company