Hunter 44110 Owner's Manual - Page 43
Span setting mode - allows you to adjust
View all Hunter 44110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
ICONS AND FEATURES, CONT. 2. Span setting mode - allows you to adjust the system ON/OFF cycle rate. The default setting is 2 (the system cycles ON or OFF when the temperature is within 1o F (0.5o C) above and below the set temperature.) The span setting can be adjusted if your system is cycling too fast or too slowly. Press and hold both the U and D buttons until the word SPAN appears. Use the U or D button to adjust the span setting. (Up will increase your cycle time by allowing the system to run longer; Down will decrease your cycle time by causing the system to run for a shorter length of time.) Span settings remain the same for HEAT and COOL system settings. When batteries are installed, or the unit is RESET, the span cycle will revert to 2. 41