Husqvarna AUTOMOWER 220 AC Owners Manual - Page 33
Installation of the guide wire, Need of a guide wire
View all Husqvarna AUTOMOWER 220 AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
3. INSTALLATION 3.8 Installation of the guide wire The guide wire is an extra wire that is laid from the charging station, out towards a remote part of the working area or through a narrow passage and is then connected to the boundary wire. The same wire used for the boundary wire is also used for the guide wire. Up to two guide wires can be installed for 230 ACX. In similarity to the boundary wire, the guide wire can either be stapled down or buried. When a guide wire is installed, Automower can also be set to follow the guide wire out from the charging station using the function Follow loop out (3-2-1), see page 52. Need of a guide wire The guide wire may be necessary in installations where the search methods Irregular and Follow boundary wire are not adequate for the mower to quickly and easily find the charging station. A few examples of installations where a guide wire is recommended follow below: • Narrow passages. In passages where the distance between the boundary wires is less than 10 ft, it is recommended to install a guide wire through the passage. This is a better solution than allowing Automower to follow close to the boundary wire by setting a low Corridor width value. • The boundary wire runs along a steep slope (steeper than 25 %). When Automower follows the boundary wire that runs along a steep slope, the mower will change direction and run away from the boundary wire. • Numerous or large islands. If Automower is permitted to follow the boundary wire it may circle an island roughly twice before it leaves the island and once again searches for the boundary wire. 34 - English 3012-736US