Husqvarna AUTOMOWER 550 EPOS Owner Manual - Page 20

has a lot of slopes or obstacles, you need to increase the Schedule settings. A 3.9 Settings in Automower® Connect The product has factory settings but the settings can be adapted to each work area. 3.9.1 Schedule Model Automower® 550 EPOS Approximate operation capacity, m2/h / ft2/h 208 / 2240 Example: A lawn of 3000 m2 / 32000 ft2, cut with an Automower® 550 EPOS. 3000 m2 / 208 ≈ 14.5 h. 32000 ft2 / 2240 ≈ 14.5 h. Days / week h / day 7 14.5 Schedule settings 7:00 - 21:30 / 7:00 am 9:30 pm 3.9.2 Cutting height In Schedule you can change the schedule settings for the product. The Schedule is set individually for each work area connected to the charging station. Secondary areas cannot be scheduled. The schedule function controls which hours the product should operate and not operate. When the product is not operating it is parked in the charging station. The operating hours and days can be seen in an overview in the Automower® Connect app. The default schedule setting allows the product to operate around the clock 7 days a week. This is normally a suitable setting for a work area corresponding to the maximum capacity. If the work area is less than the maximum capacity the schedule should be used to minimize wear on the grass and to the product. To calculate the schedule setting, refer to To calculate the schedule setting on page 20. 3.9.1.1 To calculate the schedule setting 1. Calculate the dimension of your lawn in m2 / ft2. 2. Divide the m2 / ft2 of the lawn with the approximate operation capacity. Refer to table below. 3. The result is equal to the number of hours that the product must operate each day. Note: The operation capacity is approximate and is calculated for flat and open work area. If the work area The cutting height is set individually for each work area. The cutting height can be set to 20-60 mm / 0.8-2.4 in. 3.9.3 Operation In the Operation's menu it is possible to change the settings of the Weather timer, ECO mode and Spiral cutting. 3.9.3.1 Spiral cutting If the product enters an area where it senses the grass is longer than average, it can change the movement pattern to Spiral cutting. This means that the product mows in a spiral pattern to faster cut the area with longer grass. It is possible to set the intensity of the Spiral cutting. Very low / Low intensity means that Spiral cutting begins less often. High / Very high intensity means that Spiral cutting begins more often. Note: Spiral Cutting does not start in slopes steeper than 15%. 20 - Installation 1576 - 003 - 30.12.2020