Husqvarna AUTOMOWER 550 EPOS Owner Manual - Page 22
Automower, Connect Bluetooth, 9.8 Messages Bluetooth, 9.9 Download firmware over the air,
View all Husqvarna AUTOMOWER 550 EPOS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
3.9.6.2 Change PIN code You can change the PIN code in the Automower® Connect app. Make a note of the new PIN code in Memo. Refer to Introduction on page 3. 3.9.6.3 Theft protection In the Theft protection menu it is possible to set the alarm duration and also what events should trigger the alarm. The factory setting is to require PIN code and the alarm duration is 1 min. Require PIN code This function means that the product cannot be operated or controlled after the STOP button has been pushed without first entering the correct PIN code. If the incorrect PIN code is entered 5 times, the product is locked for a time. The lock is extended for each new incorrect try. Alarm duration There is a possibility to set how long the alarm signal should last. A setting between 1 and 10 minutes is possible. STOP button pressed If the alarm "STOP button pressed" is enabled, the alarm goes off if someone presses the STOP button and the PIN code is not entered within 30 seconds. Carried away If the alarm Carried away is enabled, the product senses unexpected motions, and the alarm goes off. 3.9.6.4 GeoFence GeoFence is a GPS-based theft protection that makes a virtual fence for the product. If the product is more than a set distance away from the center position the product will be deactivated and an alarm will start. The center position will be set to the current position of the product when the function is enabled. The PIN code is needed to deactivate the alarm and to start the product again. The GeoFence is only enabled when the product is switched on. 3.9.7 Automower® Connect (Bluetooth® only) Note: The Messages menu is only available for Bluetooth® short-range connectivity. If the product is disrupted in any way, for example it is trapped or the battery is low, a message is saved relating to the disruption and the time it happened. If the same message is repeated several times, this may indicate that an adjustment to the installation or the product is required. Refer to Installation on page 12. 3.9.9 Download firmware over the air (Firmware over the air FOTA) The product has a function that automatically downloads new firmware. When a new firmware is available, a notification shows in the app where you can select to install the new firmware. In the factory setting this function is enabled. In Automower® Connect you can enable or disable the Automower® Connect module. You can also see the signal strength, connectivity status, initiate new pairing or remove the product from the paired accounts. 3.9.8 Messages (Bluetooth® only) In this menu the previous fault and information messages can be found. For some of the messages, there are tips and advice to help to rectify the fault. 22 - Installation 1576 - 003 - 30.12.2020