Home » Husqvarna Manuals » Lawn Mowers » Husqvarna AUTOMOWER 550H » Manual Viewer

Husqvarna AUTOMOWER 550H Owner Manual - Page 39

Alarm! Mower til

View all Husqvarna AUTOMOWER 550H manuals

Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

Message Cause Action Charging station blocked The contact between the charging strips and contact strips may be poor and the product has made a number of attempts to charge. Put the product in the charging station and check that the charging strips and contact strips make good contact. An object is obstructing the product. Remove the object. The charging station is tilted or bent. Confirm that the charging station is placed on a fully flat and horizontal ground. The charging station must not be tilted or bent. Stuck in charging station There is an object in the way of the product preventing it from leaving the charging station. Remove the object. Upside down The product is leaning too much or has Place the product on a flat, level sur- turned over. face, and start the product again. Needs manual charging The product is set to the Secondary area operating mode. Place the product in the charging station. This behavior is normal and no action is required. Next start hh:mm The timer setting prevents the product Change the timer settings. Refer to from operating. Timer settings on page 22. The clock on the product is not correct. Set the time. Refer to Time & Date on page 27. Lifted The lift sensor has been activated as the product has become trapped. Free the product. Collision sensor The body of the product can not move Check that the body of the product can problem, front/rear freely around its chassis. move freely around its chassis. If the problem remains, the message requires action by an authorized service technician. Wheel drive prob- Grass or other object is wrapped lem, right/left around the drive wheel. Clean the wheels and around the wheels. Alarm! Mower stopped Alarm! Mower lifted The alarm was activated because the product was stopped. The alarm was activated because the product was lifted. Adjust the mower security settings in the Security menu. Refer to Security (Bluetooth® only) on page 27. Alarm! Mower til- The alarm was activated because the ted product was tilted. 1102 - 002 - Troubleshooting - 39

Section	Page
Contents	2
Introduction	3
Support	3
Product description	3
Automower® Connect	3
Product overview	4
Symbols on the product	5
Symbols in Automower® Connect	6
Symbols on the battery	6
Overview of the settings structure (1)	7
Overview of the settings structure (2)	8
Overview of the settings structure (3) (Bluetooth® short-range connectivity only)	9
Safety	10
Safety definitions	10
General safety instructions	10
IMPORTANT. READ CAREFULLY BEFORE USE. KEEP FOR FUTURE REFERENCE	11
Safety instructions for operation	12
Use	12
Battery safety	13
How to lift and move the product	13
Maintenance	14
In the event of a thunderstorm	14
Installation	15
Introduction - Installation	15
Before the installation of the wires	15
Before the installation of the product	15
To examine where to put the charging station	15
To examine where to put the power supply	16
To examine where to put the boundary wire	16
To put the boundary wire in a slope	17
Passages	17
To make an island	17
To make a secondary area	17
To examine where to put the guide wire	18
Work area examples	18
Installation of the product	19
To install the charging station	19
To install the boundary wire	19
To install the guide wire	20
To put the wire into position with stakes	20
To bury the boundary wire or the guide wire	20
To change the position of the boundary wire or the guide wire	20
To extend the boundary wire or the guide wire	21
After the installation of the product	21
To do a visual check of the charging station	21
To start the product for the first time	21
Automower® Connect	21
To install Automower® Connect	22
To pair Automower® Connect and the product	22
Automower® Connect menu	22
Dashboard	22
Map	22
Map settings	22
Settings in Automower® Connect	22
Timer settings	22
To calculate the timer setting	23
Edit timer settings	23
Edit current timer settings	23
Add a new timer setting	23
Cutting height	23
To set the cutting height	23
Operation	23
Weather timer	23
ECO mode	24
Spiral cutting	24
Installation	24
Methods for the product to find the charging station	24
Finding the charging station	25
Lawn coverage	25
To disable and enable the GPS function	25
Area 1-5 > Enable/disable	25
Area 1-5 > How? and How far?	25
Area 1-5 > How often?	25
Corridor width	25
To set the corridor width of the boundary wire	25
To set the corridor width of the guide wire	26
Exit angles	26
Exit angles > Sectors	26
To set the reversing distance	26
To set the Drive Past Wire function	26
Accessories	26
Mower house	26
Ultrasonic	27
General (Bluetooth® only)	27
Time & Date	27
To reset to factory settings	27
Security (Bluetooth® only)	27
To create a new loop signal	27
Change PIN code	27
Theft protection	27
Alarm duration	27
Lifted	27
Turned upside down	27
STOP button pressed	27
Time lock	28
GeoFence	28
Automower® Connect (Bluetooth® only)	28
Messages (Bluetooth® only)	28
My mowers	28
Automower® Direct	28
To start to use Automower® Direct	29
Husqvarna Fleet Services™	29
To connect to the product with Husqvarna Fleet Services™	29
Operation	30
Main switch	30
Start	30
Operating mode - Start	30
Main area	30
Override timer	30
Secondary area	31
Operating mode - Park	31
Park until further notice	31
Start on next timer	31
Parking duration	31
The charging station's park button	31
Operating mode - Pause	31
Stop	31
Switch off	31
Charge a flat battery	32
Maintenance	33
Introduction - maintenance	33
Clean the product	33
Chassis and blade disc	33
Chassis	33
Wheels	33
Cover	33
Charging station	33
Replace the blades	34
To replace the blades	34
Battery	34
Winter service	35
Troubleshooting	36
Introduction - troubleshooting	36
Fault messages	36
Information messages	41
LED indicator lamp on the charging station	43
LED indicator lamp on the product	44
Symptoms	45
Finding breaks in the loop wire	46
Transportation, storage and disposal	49
Transportation	49
Storage	49
Disposal	49
To remove the battery	49
Technical data	50
Technical data	50
Registered trademarks	52
Warranty	53
Guarantee terms	53
Applicable to US/CA market	54
Supplier's Declaration of Conformity	54

Match case Limit results 1 per page

Message

Cause

Action

Charging station

blocked

The contact between the charging

strips and contact strips may be poor

and the product has made a number of

attempts to charge.

Put the product in the charging station

and check that the charging strips and

contact strips make good contact.

An object is obstructing the product.

Remove the object.

The charging station is tilted or bent.

Confirm that the charging station is

placed on a fully flat and horizontal

ground. The charging station must not

be tilted or bent.

Stuck in charging

station

There is an object in the way of the

product preventing it from leaving the

charging station.

Remove the object.

Upside down

The product is leaning too much or has

turned over.

Place the product on a flat, level sur-

face, and start the product again.

Needs manual

charging

The product is set to the

Secondary

area

operating mode.

Place the product in the charging sta-

tion. This behavior is normal and no ac-

tion is required.

Next start hh:mm

The timer setting prevents the product

from operating.

Change the timer settings. Refer to

Timer settings on page 22

The clock on the product is not correct.

Set the time. Refer to

Time & Date on

page 27

Lifted

The lift sensor has been activated as

the product has become trapped.

Free the product.

Collision sensor

problem, front/rear

The body of the product can not move

freely around its chassis.

Check that the body of the product can

move freely around its chassis.

If the problem remains, the message

requires action by an authorized serv-

ice technician.

Wheel drive prob-

lem, right/left

Grass or other object is wrapped

around the drive wheel.

Clean the wheels and around the

wheels.

Alarm! Mower

stopped

The alarm was activated because the

product was stopped.

Adjust the mower security settings in

the

Security

menu. Refer to

Security

(Bluetooth

only) on page 27

Alarm! Mower lif-

ted

The alarm was activated because the

product was lifted.

Alarm! Mower til-

ted

The alarm was activated because the

product was tilted.

1102 - 002 -

Troubleshooting -