Husqvarna RZ5424 Kawasaki Owners Manual - Page 39
Deck Belt, Deck Belt Removal, Deck Belt Installation
View all Husqvarna RZ5424 Kawasaki manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
MAINTENANCE Deck Belt Deck Belt Removal Park on a level surface. Apply park brake. Lower the deck into the lowest cutting position. 1. Remove foot plate and belt shields. 2. Using a ratchet or breaker bar with a 9/16" socket on the spring idler bolt, relieve the tension on the belt. 3. Remove any dirt or grass that may have accumulated around the cutter housings and entire deck surface. 4. Carefully slip the belt over the top of the cutter housing pulleys. 5. Remove the belt from around the electric clutch on the engine shaft and off the mower deck. Slackening the belt tensioner 8058-063 Deck Belt Installation NOTE: For ease in installing the deck belt, refer to the routing decal on the deck. 1. Wrap the deck belt around the electric clutch pulley that is located on the engine shaft. 2. Route the belt forward between the spring loaded and stationary pulleys. 3. Place belt around spring loaded idler pulley. 4. Wrap the belt around the stationary idler pulley and around the mandrel housings. 5. Push inward on the idler arm and carefully route belt over stationary idler pulley. Once the belt is properly routed, slowly release the idler arm to tighten the belt. 6. Check that there are no twists in the belt and that the routing matches the routing decal. 7. Replace belt shields on both mandrel housings and secure with fasteners. 1 3 2 5 Belt routing, deck belt 4 8058-061 39