Husqvarna T525 Owner Manual - Page 17
Maintenance
View all Husqvarna T525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Maintenance Introduction WARNING: Read and understand the safety chapter before you do maintenance on the product. Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Clean the external parts of the prod- Clean the cooling system. Refer to Do a check of the brake band. Refer uct and make sure that there is no oil To clean the cooling system on page to To do a check of the brake band on the handles. 27. on page 18. Do a check of the throttle trigger and Do a check of the starter, starter rope Do a check of the clutch centre, throttle trigger lockout. Refer to To do and return spring. clutch drum and clutch spring. a check of the throttle trigger and the throttle trigger lockout on page 19. Make sure that there is no damage on the vibration damping units. Lubricate the needle bearing. Refer Clean the spark plug. Refer to To do to To lubricate the needle bearing on a check of the spark plug on page page 26. 22. Clean and do a check of the chain brake. Refer to To do a check of the chain brake on page 18. Remove burrs from the edges of the guide bar. Refer to To do a check of the guide bar on page 26. Clean the external parts of the carburettor. Do a check of the chain catcher. Re- Clean or replace the spark arrestor fer to To do a check of the chain mesh on the muffler. catcher on page 19. Do a check of the fuel filter and the fuel hose. Replace if necessary. Turn the guide bar, do a check of the lubrication hole and clean the groove in the guide bar. Refer to To do a check of the guide bar on page 26. Clean the carburetor area. Do a check of all cables and connections. Make sure that the guide bar and saw chain are getting sufficient oil. Clean or replace the air filter. Refer Empty the fuel tank. to To clean the air filter on page 22. Do a check of the saw chain. Refer to Clean between the cylinder fins. To examine the cutting equipment on page 26. Empty the oil tank. Sharpen the saw chain and do a check of its tension. Refer to To sharpen the saw chain on page 22. Do a check of the chain drive sprocket. Refer to To do a check of the spur sprocket on page 26. Clean the air intake on the starter. Make sure that nuts and screws are tightened. Do a check of the stop switch. Refer to To do a check of the start/stop switch on page 19. 732 - 017 - 11.10.2019 17