Husqvarna V548 - 2023 Owner Manual - Page 4
Stand on or walk behind position, Steering controls, Operator Presence Control (OPC), Ignition key
View all Husqvarna V548 - 2023 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
11. PTO button 12. Transport latch 13. Parking brake 14. Fuel shut-off valve 15. Deck lifting lever 16. Type plate 17. Adjustment levers for the adjustable bar 18. Adjustable bar Stand on or walk behind position The product can be operated as a stand on or walk behind lawn mower. The latch on the rear part of the product holds the stand on platform in a folded position. Refer to To set the product in stand on or walk behind position on page 11. • Run with accessory / headlights position (B) • Run position (C) • Start position (D) A B C D Throttle control The throttle control adjusts the speed of the engine and the speed of the blades if the blades are engaged. The throttle control has 2 end positions, idle speed and full throttle. A B Steering controls The direction of the product is controlled by the 2 control levers. Refer to Product overview on page 3. The control levers can be moved forward and rearward from a neutral position. Refer to To operate the product on page 13. Operator Presence Control (OPC) The OPC engages when the operator lifts the hands from the control levers. The engine and the drive to the blades stop if the blades are engaged or the parking brake is not applied. Refer to Operation conditions on page 8. Ignition key The ignition key is used to start and stop the engine. The ignition key has 4 positions: • Stop position (A) • Idle speed (A) - decreases the engine speed. • Full throttle (B) - increases the engine speed. CAUTION: Do not operate the engine at idle speed (A) for longer time than necessary. Too much operation time at idle speed can decrease the life of the spark plugs. Choke control The choke control is used for cold starts to supply more fuel to the engine. Pull up the choke control when you start a cold engine. Refer to Product overview on page 3 for the position of the choke control. PTO (Power Take-Off) button The PTO button engages and disengages the PTO clutch and the cutting deck or other equipment connected to it. The correct start conditions must be obeyed to engage the drive of the blades. Refer to Operation conditions on page 8 for the correct start conditions. 4 1994 - 002 - 05.12.2022