IBM 172319X Installation Guide - Page 21
rail-adjustment
![]() |
UPC - 883436045230
View all IBM 172319X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2. Select a 1U location in the rack for the console unit. Install either three cage nuts or three clip nuts in the front of the rack. Install two cage nuts or two clip nuts in the rear of the rack. Use the cage nuts or clip nuts from the miscellaneous hardware kit. Note: If you are installing an optional console switch behind the console unit, make sure that you install a cage nut or clip nut in the center-rear position that is shown shaded in the following illustration. U U U U U U U U U U U U Front Rear Optional console-switch nut 3. If you are installing the console unit in an IBM rack cabinet, no adjustment is necessary. Otherwise, loosen the two rail-adjustment screws on each of the outer slide rails and extend the rails to their maximum outward position. Rail-adjustment screws Chapter 2. Installing the console unit in the rack cabinet 11
![](/manual_guide/products/ibm-17231rx-installation-guide-c9f8044/21.png)