IBM 436854u Service Guide - Page 88
Removing a simple-swap hard disk drive
UPC - 883436026772
View all IBM 436854u manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Removing a simple-swap hard disk drive This procedure applies only to server models that have simple-swap SATA hard disk drives. Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before you remove or install a simple-swap hard disk drive. To remove a simple-swap hard disk drive, complete the following steps: 1. Read the safety information that begins on page vii and "Installation guidelines" on page 47. 2. Turn off the server and all attached devices; then, disconnect all power cords and external cables. 3. Unlock the side cover. The side cover does not have to be removed. 4. Remove the lower bezel (see "Removing the lower bezel" on page 54). 5. Pull the loops of the drive assembly that is to be removed toward each other; then, pull the assembly out of the bay. 6. If you are instructed to return the drive assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. 70 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide