IBM 4800-741 Hardware Service Guide - Page 51
Removing, CD-ROM
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Updated July 14, 2008 Removing the CD-ROM Follow these steps to remove the CD-ROM: Models with the front-service housing option For models with front-service housing installed, follow these instructions: 1. Remove the front bezel as follows: a. See Figure 17 on page 29. Press the left latch and depress the center latch to loosen the bezel. b. Press the right latch to release the bezel and pull it forward, lifting the bezel from the machine. Figure 21. Opening units with front-service housing 2. See Figure 21. Press upward on the left latch and use the pull-out handle to extend the system unit from the housing until it stops. Note: Be sure to use a cart to support the system unit if it is completely removed. 3. Open the media access door by removing the two screws. 4. Continue with step 3 on page 34 below. 5. To replace, reverse these steps. For all other models: 1. Follow the instructions in "Removing the covers" on page 29 to remove the front bezel and top cover. Chapter 2. Removal and replacement procedures 33