IBM 4800-741 Hardware Service Guide - Page 54
Removing, drive
![]() |
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Updated July 14, 2008 Removing the hard disk drive Models with the front-service housing option For models with front-service housing installed, follow these instructions: 1. Remove the front bezel as follows: a. See Figure 17 on page 29. Press the left latch and depress the center latch to loosen the bezel. b. Press the right latch to release the bezel and pull it forward, lifting the bezel from the machine. 2. See Figure 21 on page 33. Press upward on the latch and use the pull-out handle to extend the system unit from the housing. Note: Be sure to a cart to support the system unit if it is completely removed. 3. Open the media access door by removing the two screws. 4. If installed, follow the instructions in "Removing the CD-ROM" on page 33. 5. Continue with step 4 on page 37 below. 6. To replace, reverse these steps. For all other models: Follow these steps to remove and replace the hard disk drive: 1. Follow the instructions in "Removing the covers" on page 29 to remove the front bezel and top cover. 2. Follow the instructions in "Removing the top plate" on page 32 to remove the top plate. 3. If installed, follow the instructions in "Removing the CD-ROM" on page 33. 36 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
![](/manual_guide/products/ibm-4800741-hardware-service-guide-41984db/54.png)