IBM 4800-741 Hardware Service Guide - Page 64
procedures.
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Updated July 14, 2008 M N Figure 34. Heat sink and processor Models 7x1 5. Locate the heat sink latches on each side of the heat sink. 6. Press down to unlock each latch and then lift upward on the heat sink ( M ) to remove. Note: When the heat sink is removed, you can locate the processor ( N ) 7. See Figure 34. Press down on the processor latch, and move sideways and up to unlock. Lift out the processor, carefully keeping your fingers on each side of the module. 8. Go to step 10. Models 7x2 9. Loosen the four captured screws to remove the heat sink. All Models 10. To replace the processor and heat sink, reverse these procedures. Note: Models 742 and 782 contain a LGA 775 CPU socket. This socket contains very finely pitched pins. You must take care when servicing the CPU as any damage to the socket results in a non-functional system board. Be sure to use the section cup tool provided with the FRU processor. 46 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide