IBM 6400-I10 Operation Guide - Page 101
Setup Guide
View all IBM 6400-I10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
046 EC STOPPED AT STATE 056 HAMMER COIL OPEN 057 CLOSE PLATEN 058 SHUTTLE JAM 059 CANCEL PRINT ACTIVE 060 PRINTER HOT 062 EXHAUST FAN FAULT status and fault messages Controller self-test and initialization sequence were halted at , where is one of 10 numerically coded messages. Contact an IBM service representative. Electrical malfunction of one or more hammer coils. Contact an IBM service representative. Forms thickness lever is raised to the open position. Lower the forms thickness lever. No shuttle movement or the shuttle is moving at the wrong speed. Make sure the ribbon is not twisted and the forms thickness lever is set to match thickness of media being used. If the fault recurs, contact an IBM service representative. Status message displayed when SCS print job is cancelled. No action necessary. Controller board sensors report high temperatures on the board. Contact an IBM service representative. Sensors cannot detect current in fan circuit. Refer to the Setup Guide for correction procedure. If this message appears on a Pedestal model, contact an IBM service representative. Operator's Guide 87