IBM 79717au User Guide - Page 49
Installing, bezel, assembly
UPC - 883436004305
View all IBM 79717au manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Installing the bezel assembly The following illustration shows how to install the blade server bezel assembly. The illustration and instructions also apply to the MPE bezel assembly, except that the MPE does not have a control-panel connector. Bezel-assembly release (both sides) Bezel assembly Control-panel cable Control-panel connector To install the blade server bezel assembly, complete the following steps: 1. Read the safety information beginning on page v and "Installation guidelines" on page 17. 2. If installing the bezel assembly on a blade server, connect the control-panel cable to the control-panel connector on the system board. Note: The MPE does not have a control-panel connector. 3. Carefully slide the bezel assembly onto the blade server, or MPE, until it clicks into place. Chapter 3. Installing options 37