Icom IC-R6 Instruction Manual - Page 46
Memory/all bank/bank link/bank scan
View all Icom IC-R6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
6 SCAN OPERATION ■ Memory/all bank/bank link/bank scan q Push [V/M] to select the memory mode. w Set the squelch level. e H old down [SCAN](MODE) for 1 second to enter the scan type selection mode. r Rotate [DIAL] to select a desired scanning type. • Select "M-ALL" for all memory scan, "B-ALL" for all bank scan, "B-LINK" for bank link scan or "BANK-x" for bank scan (x= A to R, T, U, W, Y; only programmed bank groups are displayed). t To start the scan, push [SCAN](MODE). • The scan pauses when a signal is received. • Rotate [DIAL] to change the scanning direction. This also resumes scanning. • Push [SCAN](MODE) again to stop the scan. During memory/ all bank/bank link scan During bank scan [DIAL] Hold down for 1 sec. Rotate • All memory scan • Bank link scan IMPORTANT: To perform a memory or bank scan, two or more memory/bank channels MUST be programmed, otherwise the scan will not start. • All bank scan • Bank scan Selectable between "A" to "R," "T," "U," "W" or "Y," if programmed (p. 20) See page 53 for details of the bank link programming. 33