Icom ID-52A About The Dv Gateway Function - Page 15

3 Terminal mode operation ■■Operating in the Terminal mode DDSetting "TO" (Destination) to make a call "CQCQCQ," the destination repeater, or station call sign must be set in "TO" when you make a DV mode call. You have 7 ways to set the destination. By rotating [DIAL] Rotate [DIAL] to select the repeater or Your Call Sign displayed on the DR screen. (This operation is disabled when "CQCQCQ" is set.) LL You can select the "Local CQ," but cannot make a call. To make a Gateway CQ call "Gateway CQ" setting (p. 16) Select a repeater from the Repeater List, if you want to make a Gateway call. To make a call to a specific station "Your Call Sign" setting (p. 17) Select the station call sign in the Your Call Sign list. NOTE: In the Terminal mode, you can make a Gateway CQ call or a call to a specific station using call sign routing. TIP: How to change the repeater group: When "Gateway CQ" is selected, you can change the repeater group. To change the repeater group on the DR screen, push [QUICK], then select "Group Select." TO SELECT screen LL You cannot make a call through a reflector. To select from RX History Setting from the RX History* When you receive a call, repeater or caller station data is saved in RX History. Select the destination from the record. To select from TX History Setting from the TX History* When you make a call, the destination repeater or called station data is saved in TX History. Select the destination from the record. To directly enter the destination station call sign Direct Input (UR)* Directly enter the destination station's call sign. To directly enter the destination repeater call sign Direct Input (RPT)* Directly enter the destination repeater's call sign. * See the transceiver's Advanced manual for details. ID-31A PLUS/ID-31E PLUS: Section 4 ID-51A (PLUS2)/ID-51E (PLUS2): Section 8 ID-52A/ID-52E: Section 5 15