Icom IP740D Instruction Manual - Page 8

2 BEFORE USING Function display Cellular mode DDCellular mode Displays the signal strength level by 3 bars. LLThe connected network type (4G or 3G) is displayed on the left top. ••Blinks when the transceiver location is out of the service area, or cannot receive a control signal. ••Displayed if the transceiver has not been authenticated. LLThe connected network type (4G or 3G) is displayed on the left top. All/Group Call Talkgroup Call*1 Individual Call Phone Call*1 ••Displayed when the Pocket Beep function is ON. (p. 3-8) ••Blinks when a call is received. It blinks until the transceiver returns to the standby mode after a received signal disappears. Displayed when the P-Bell function is ON. (p. 3-8) DDIDAS mode Displays the relative receive signal strength level. Displayed when the signal level is low. All/Group Call Individual Call Displayed when the Encryption function is ON. (p. 4-4) Displayed*2 when high output power is selected. Displayed*2 when low output power is selected. LL"L2" is displayed for 2 W, "L1" is displayed for 1 W. Displayed*2 when a receive-only channel is selected. Displayed when the channel is in the audible (unmuted) mode. IDAS mode DDCellular/IDAS mode ••Displayed when the Record function is ON. (p. 5-9) ••Blinks while recording audio. Displayed when Bluetooth is activated. (p. 5-2) Displayed when a Bluetooth device is connected. (p. 5-2) Displayed when the Key Lock function is ON. (p. 2-4) Displayed when the VOX function is ON. (p. 6-3) Displayed when the Emergency Call function is ON. (p. 5-5) Displays the remaining battery charge. : Full : Mid : Charging required : Battery exhausted F Blinks when the transceiver is downloading a new firmware. Displayed when the Surveillance function is ON. (p. 5-10) *1 May be usable, depending on a presetting. *2 Blinks when the transceiver temperature becomes hot. 2-3