Insignia NS-32D311NA17 User Manual English - Page 21

Connecting an antenna or cable TV (no box) On your TV Antenna or cable TV (no box) 40" 1080p 60Hz LED TV Coaxial cable connector Coaxial cable ANT / CABLE IN jack Back of TV 1 Make sure that your TV's power cord is unplugged and all connected devices are turned off. 2 Connect a coaxial cable (not provided) to the ANT / CABLE IN jack on the back of your TV and to the antenna or cable TV wall jack. 3 Plug your TV's power cord into a power outlet, then turn on your TV. 4 Press INPUT to open the Input Source list. 5 Press S or T to highlight TV, then press ENTER. 6 If you cannot tune to channels you know exist, scan for channels. See Automatically scanning for channels on page 46. Notes • Use a coaxial cable to eliminate interference and noise from radio waves. • Do not bundle the coaxial cable with the power cord or other cables. • If the antenna is not installed correctly, contact qualified service personnel to correct the problem. • If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a highly directional outdoor or set-top antenna with a built-in amplifier. • If the picture quality is good on some channels and poor on others, the problem may be caused by a poor or weak signal from the broadcaster or cable TV provider. • If you connect to cable TV without a set-top box and experience poor picture quality, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable TV provider about upgrading to a set-top box. • Many high-definition (HD) channels upscale standard-definition (SD) content. The picture displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it would be if the content was originally recorded in HD. www.insigniaproducts.com 17