Insignia NS-FDRE67WH8A User Guide - Page 16

INSTALLATION INSTRUCTIONS Installing your dryer Important: We recommend that you use a qualified installer to install your dryer. Tools you will need Pliers Phillips screwdriver Level Pipe wrench Flat-head screwdriver Adjustable wrench that opens to 1" (25 mm) Duct tape Cutting knife Materials you will need • 3/8" Gas Dryer Install Kit (Gas model only) • 3 or 4-prong (dependent on owners house) Electric Kit. (electric model only) • Exhaust kit Before you start Before you start installing your dryer, make sure that: • The location you selected has a grounded electrical outlet. See Grounding requirements on page 15. • For U.S. models, you have the correct type power cord (not included). See Electric requirements-U.S. only on page 13. Note: For Canadian models, the power cord comes pre-installed. • Your exhaust ducting (not included) is made of rigid metal or flexible stiff-walled metal. See Ducting requirements on page 12. • You have a 3/8" Gas Dryer Install Kit (if you are installing a gas dryer) must meet all national and local codes. Step-by-Step instructions Note: If a gas dryer is being installed, you will need to call a licensed professional to do the installation. Step 1: Make sure that the floor is a solid, level surface • Use a level to make sure that the floor where you are installing your dryer is level. This helps minimize vibration, noise, and unwanted movement. Step 2: Move your dryer to the location you selected • Move your dryer to the location you selected, but do not push your dryer all the way back into the location. You need to connect the power cord and ducting before you move your dryer into its final position. Tip: For information about space requirements for a side-by-side installation, see Installing your dryer and washer side-by-side on page 10. 16 www.insigniaproducts.com