Insignia NS-R2000 User Manual (English) - Page 16

Category Problem Possible Solution Remote control unit does not operate. 1 Batteries are not loaded or are exhausted. 2 The remote sensor is obstructed. 1 Replace the batteries. 2 Remove the obstacle. Specifications Note • • • Design and specifications are subject to change without notice. Weight and dimensions shown are approximate. Specifications and external appearance may be changed for the sake of improvement. Amplifier Power output, stereo mode, 8 Ω, THD 1%, 40 Hz~20 kHz: 2×100 W Total harmonic distortion, 8 Ω, 100 W, 40 Hz~20 kHz: 0.04% Intermodulation distortion 60 Hz, 7 kHz= 4:1 SMPTE, 8Ω, 100 W: 0.02 % Input sensitivity, 47 kΩ, Phono (MM): 2.5 mV Input sensitivity, 47 kΩ, Line (CD, TAPE, AUX): 200 mV Signal to noise ratio, IHF "A" weighted, Phono (MM): 70 dB Signal to noise ratio, IHF "A" weighted, Line (CD, TAPE, AUX): 95 dB Frequency response Phono (MM), RIAA, 30 Hz~20 kHz: 8 dB +/- 3 dB Frequency response Line (CD, TAPE, AUX), 20 Hz~100 kHz: 8 dB +/- 3 dB Output level TAPE/AUX OUT, 2.2 kΩ: 200 mV Bass/Treble control, 100 Hz/10 kHz: ±10 dB FM Tuner Tuning frequency range: 87.5~108 MHz Usable sensitivity, THD 3%, S/N 30 dB: 15 dBf 50 dB quieting sensitivity, mono/stereo: 25.2 / 45.2 dBf Signal to noise ratio, 65 dBf, mono/stereo: 68/65 dB Total harmonic distortion, 65 dBf,1 kHz, mono/stereo: 0.5 / 0.8% Frequency response, 20 Hz~14 kHz: 8 dB +/- 3 dB Stereo separation, 1 kHz: 40 dB Capture ratio: 4 dB IF rejection ratio: 80 dB AM Tuner Tuning frequency range: 520~1710 kHz Usable sensitivity: 800 µV/m Signal to noise ratio: 40 dB Selectivity: 25 dB General Power supply: 120 V ~ 60 Hz Power consumption: 2.5 A Dimensions (W×H×D, including protruding parts): 17-3/8×5-1/2×14-3/4 inches (440×141×376 mm) Weight (Net): 19.8 lbs (9.0 kg) Insignia NS-R2000 Stereo Receiver Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. Canada ICES-003 statement This Class B digital apparatus complies with Canadian ICES-003. Copyright © 2007 Insignia. Insignia and the Insignia logo are trademarks of Best Buy Enterprise Services, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. Specifications and features are subject to change without notice or obligation. For service and support call (877) 467-4289. 14 www.insignia-products.com