Insignia NS-SB515 User Manual English - Page 18

Insignia Soundbar with Wireless Subwoofer Mounting your soundbar on a wall (optional) You will need: TOOLS NEEDED Drill a hole here Wall anchors (2) Screws (2) #10 × 1 ½ in. (3.8 cm) wood screw (or similar) Wall mount template Locate/Position holes onto studs behind drywall when possible, -or use anchors for mounting Warning: Improper installation can result in serious injury or damage to your soundbar. If necessary, seek the assistance of a professional. HOLD THE LEVEL TO THE TOP EDGE OF THIS TEMPLATE Center Line Determine where you would like to mount the soundbar. The center line of the template should match the center of the TV. Note: If you are mounting to drywall, use a studfinder to locate studs. A wall anchor is not needed if you are attaching to a stud. Hold this template in the location you want, and use a level to level it, then tape it to the wall. Wall Drill two holes at the indicated points. Scale: 1/1 Center Line Wall Anchor Remove the template from the wall. You must use suitable wall anchors (not supplied) if you cannot mount the soundbar to available wall studs. Wall 1/4 in. (6 to 8 mm) Fasten two screws (not supplied) to the wall. The screw heads should protrude from the wall approximately 1/4 in. (6 to 8 mm). The screw width must be about 3/16 in. and the screw head about .3 in. (7.6 mm) to 3/8 in. (9.5 mm). Soundbar Wall Align the speaker hanging brackets with the screws, then hang the soundbar on the screws. Drill a hole here Center Line Wall mounting template Level Stud finder (optional for wood stud installation) Drill and drill bit Hammer Screwdriver Tape measure Tape Wall anchors (2) Screws (2) - #10 x 1-1/2 in (3.8 cm) wood screw (or similar) 1 Select a location close to your TV and directly in front of the viewing/listening position. For best sound quality, choose a location where sound waves are not blocked by furniture or other obstacles. 2 If you are mounting your soundbar to drywall, use the stud finder to find the studs and mark the locations. 3 Position the supplied wall mount template to the wall where you want to mount the soundbar. Make sure that the template is level and note if it's aligned with a stud, then tape the template to the wall. 4 Drill two holes into the wall where the template indicates, then remove the template. 5 If needed, install wall anchors (not included) into the holes you drilled, using the instructions that came with your anchors. Caution Make sure that you use wall anchors that are suitable to your wall type if you need to mount the soundbar to drywall, concrete, or similar wall type. Notes • • If you have drilled into a stud, wall anchors are not required. If you cannot drill into wall studs and must drill into drywall, concrete, or another type of wall, wall anchors are required. See the instructions that came with your wall anchors to determine the drill bit size. 18 www.insigniaproducts.com