Insignia NS-TDRE75W1 User Guide - Page 17

INSTALLATION INSTRUCTIONS 10-Cycle Electric and Gas Dryers For best results, the static pressure in any exhaust system should be between 0.3 to 0.8 inches of water column, and it cannot be less than 0 under any circumstances with an installed duct with a four inch diameter. WEATHER HOOD TYPES Recommended Use only for short-run installation 4 in. (10.2 cm) 4 in. (10.2 cm) 4 in. (10.2 cm) # of 90° elbows 0 1 2 3 4 in. (10.2 cm) Rigid Metallic 90 ft. (27.4 m) 60 ft. (18.3 m) 45 ft. (13.7 m) 35 ft. (10.7 m) 2.5 inch. (6.4 cm) Rigid Metallic 60 ft. (18.3 m) 45 ft. (13.7 m) 35 ft. (10.7 m) 25 ft. (7.6 m) Electric requirements WARNING: The wiring diagram is located on the back panel of your dryer. • Incorrectly connecting your dryer's grounding conductor can result in electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether your dryer is correctly grounded. • Do not modify the plug provided with your dryer. If the plug does not fit the outlet, have the correct type outlet installed by a qualified electrician. • To prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring and grounding must be done in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70 Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1-Latest Revisions and local codes and ordinances (for Canada). • You are responsible for providing adequate electrical services for your dryer. • All gas installations must be done in accordance with the latest revision of National Fuel Code ANSI Z223.1/NFPA 54 (for US) or CSA B149.1 (for Canada) and local codes and ordinances. Electrical connections An individual branch (or separate) circuit serving only your dryer is recommended. DO NOT USE AN EXTENSION CORD. www.insigniaproducts.com 17