Insignia NS-TDRE75W1 User Guide - Page 26

Step 6: Plug in your dryer, Step 7: Check the final installation

Get Insignia NS-TDRE75W1 PDF manuals and user guides View all Insignia NS-TDRE75W1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

INSTALLATION INSTRUCTIONS 1 Remove the center terminal block screw. 2 Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw. 3 Connect the neutral wire (white or center wire) of the power cord and the appliance ground wire (white) under the center screw of the terminal block. 4 Connect the other wires to the outer terminal block screws. Be sure to cross the screw through the terminal ring and tighten the screw. 5 Tighten the strain relief screws. 6 Insert the tab of the terminal block cover into your dryer's rear panel slot, then secure the cover with a screw. Step 6: Plug in your dryer Make sure that all exhaust and electrical connections are complete, then plug your dryer into the electrical outlet. Step 7: Check the final installation • Before you use your dryer, make sure that: • The dryer is plugged into an electrical outlet and is properly grounded. • Rigid or semi-rigid metal vent material is installed. Do not use a plastic flexible ducting. • The exhaust duct work is hooked up and the joints are taped. • The dryer is level and sits firmly on the floor. • Start your dryer to confirm that it runs, heats, and shuts off. 26 www.insigniaproducts.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
26
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
1
Remove the center terminal block screw.
2
Connect the ground wire (green or unwrapped) of the power cord to the
external ground conductor screw.
3
Connect the neutral wire (white or center wire) of the power cord and the
appliance ground wire (white) under the center screw of the terminal block.
4
Connect the other wires to the outer terminal block screws. Be sure to cross
the screw through the terminal ring and tighten the screw.
5
Tighten the strain relief screws.
6
Insert the tab of the terminal block cover into your dryer’s rear panel slot, then
secure the cover with a screw.
Step 6: Plug in your dryer
Make sure that all exhaust and electrical connections are complete, then plug
your dryer into the electrical outlet.
Step 7: Check the final installation
•
Before you use your dryer, make sure that:
•
The dryer is plugged into an electrical outlet and is properly grounded.
•
Rigid or semi-rigid metal vent material is installed. Do not use a plastic
flexible ducting.
•
The exhaust duct work is hooked up and the joints are taped.
•
The dryer is level and sits firmly on the floor.
•
Start your dryer to confirm that it runs, heats, and shuts off.