Insignia NS-TDRE75W1 User Guide - Page 21

INSTALLATION INSTRUCTIONS 10-Cycle Electric and Gas Dryers Electric models WARNING: • For products sold in the U.S., your dryer has an optional cord with an equipment-grounding conductor and a grounding plug, which is sold separately. • For products sold in Canada, your dryer is equipped with a cord having an equipment-grounding conductor and a grounding plug. • The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. • If a power cord is not used and the electric dryer is to be permanently wired, this appliance must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. WARNING: • Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel, if you are in doubt as to whether the appliance is properly grounded. • Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing. Service Personnel - Do not contact the following parts while the appliance is energized: Control Board and Temperature-Regulating Thermistor (Located on the Blower Housing ). Installing your dryer Important: We recommend that you use a qualified installer to install your dryer. Tools you will need Phillips screwdriver Level Flat-head screwdriver Duct tape Pliers Pipe wrench Adjustable wrench that opens to 1" (2.5 Cm) Cutting knife Materials you will need • 3/8" gas dryer gas line (Gas model only) • 3- or 4-prong (dependent on owner's house) electric power cord (electric model only) • Phillips screwdriver • Exhaust dryer vent kit www.insigniaproducts.com 21