Insignia NS-TDRE75W1 User Guide - Page 20
Grounding requirements, Gas models, For GAS MODELS ONLY, WARNING
View all Insignia NS-TDRE75W1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
INSTALLATION INSTRUCTIONS COMMONWEALTH OF MASSACHUSETTS INSTALLATION INSTRUCTIONS Your dryer must be installed by a licensed plumber or gas fitter. A "T" handle manual gas valve must be installed in the gas supply line to the installed dryer at the location of operation. If a flexible gas connector is used to connect the dryer, the connector may not be longer than 3 ft. (36 in./91.5 cm). WARNING: Gas leaks may occur in your system, creating a dangerous situation. • Gas leaks may not be detected by smell alone. • Gas suppliers recommend that you purchase and install a UL-approved gas detector. • Install and use it in accordance with the manufacturer's instructions. Grounding requirements Your dryer must be grounded. If a malfunction or breakdown occurs, the grounding reduces the risk of electrical shock by providing a path of least resistance for the electrical current. Gas models WARNING: • This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. • The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. • Never connect the ground wire to the plastic plumbing lines, gas lines, or hot water pipes. For GAS MODELS ONLY: The burner may not ignite initially due to air in the gas line. Allowing your dryer to operate on a heat setting will purge the line. If the gas does not ignite within 5 minutes, turn your dryer off and wait 5 minutes. Be sure the gas supply to your dryer has been turned on. To confirm gas ignition, check the exhaust for heat. 20 www.insigniaproducts.com