Intel BLKD946GZABL Product Specification - Page 24
Serial ATA Interfaces
![]() |
View all Intel BLKD946GZABL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Intel Desktop Board D946GZAB Technical Product Specification 1.5.3 Serial ATA Interfaces The board provides four Serial ATA (SATA) connectors, which support one device per connector. 1.5.3.1 Serial ATA Support The ICH7's Serial ATA controller offers four independent Serial ATA ports with a theoretical maximum transfer rate of 3 Gbits/sec per port. One device can be installed on each port for a maximum of four Serial ATA devices. A point-to-point interface is used for host to device connections, unlike Parallel ATA IDE which supports a master/slave configuration and two devices per channel. For compatibility, the underlying Serial ATA functionality is transparent to the operating system. The Serial ATA controller can operate in both legacy and native modes. In legacy mode, standard IDE I/O and IRQ resources are assigned (IRQ 14 and 15). In Native mode, standard PCI Conventional bus resource steering is used. Native mode is the preferred mode for configurations using the Windows* XP and Windows 2000 operating systems. NOTE Many Serial ATA drives use new low-voltage power connectors and require adaptors or power supplies equipped with low-voltage power connectors. For more information, see: http://www.serialata.org/ For information about The location of the Serial ATA connectors Refer to Figure 14, page 48 24
![](/manual_guide/products/intel-blkd946gzabl-product-specification-6c4b019/24.png)