Intel D845GLLY D845GL_Boards_SpecUpdate09 - Page 15
Connectors, CAUTION - front panel connector
View all Intel D845GLLY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Specification Update for Intel Desktop Boards Using the Intel 845GL Chipset Figure 1 (continued) A Audio codec O B Auxiliary line-in connector P C ATAPI CD-ROM connector Q D Back panel connectors R E +12V power connector (ATX12V) S F Rear chassis fan connector T G Intel 82845GV Graphics and Memory U Controller Hub (GMCH) H mPGA478 processor socket V I Processor fan connector W J DIMM sockets X K Serial port B connector Y L I/O Controller Z M Power connector AA N Diskette drive connector IDE connectors Speaker Battery Auxiliary front panel power LED connector Front chassis fan connector Chassis intrusion connector BIOS Setup configuration jumper block 4 Mbit Firmware Hub (FWH) Front panel connector Front panel USB connector Intel 82801DB I/O Controller Hub (ICH4) PCI bus add-in card connectors Front panel audio connector Figure 1. Desktop Board D845GLAD Components 5. Change to Description of Section 2.2, Connectors Section 2.2, Connectors will change in its entirety as follows: 2.2 Connectors CAUTION Only the back panel USB, front panel USB, VGA, and PS/2 connectors have overcurrent protection. The Desktop Boards' internal connectors are not overcurrent protected and should connect only to devices inside the computer's chassis, such as fans and internal peripherals. Do not use these connectors to power devices external to the computer's chassis. A fault in the load presented by the external devices could cause damage to the computer, the interconnecting cable, and the external devices themselves. 9