Intel DQ965CO English Product Guide - Page 35

Installing the Thermal Module, Position the Thermal Module Over the Mounting Holes

Get Intel DQ965CO PDF manuals and user guides View all Intel DQ965CO manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Installing and Replacing Desktop Board Components Installing the Thermal Module Desktop board DQ965CO has four mounting holes for a BTX Thermal Module. The board will accept either a Type I or Type II Thermal Module. Use the correct Thermal Module for your chassis. To install the Thermal Module, use the following procedure: 1. With the BTX Support and Retention Module (SRM) installed in the chassis, position the Thermal Module on the desktop board with the fan end extending past the edge of the desktop board and over the exposed end of the SRM. 2. Align the four captive screws in the Thermal Module with the mounting holes in the desktop board and SRM as shown in Figure 12. Figure 12. Position the Thermal Module Over the Mounting Holes 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
Installing and Replacing Desktop Board Components
35
Installing the Thermal Module
Desktop board DQ965CO has four mounting holes for a BTX Thermal Module.
The
board will accept either a Type I or Type II Thermal Module.
Use the correct Thermal
Module for your chassis.
To install the Thermal Module, use the following procedure:
1.
With the BTX Support and Retention Module (SRM) installed in the chassis, position
the Thermal Module on the desktop board with the fan end extending past the
edge of the desktop board and over the exposed end of the SRM.
2.
Align the four captive screws in the Thermal Module with the mounting holes in the
desktop board and SRM as shown in Figure 12.
Figure 12.
Position the Thermal Module Over the Mounting Holes