Intel JBOD2000 Intel Storage System JBOD2000 Family Service Guide - Page 24

Hardware Installations and Upgrades Figure 27. Installing Hard Disk Drive - Installing 2.5" HDD 4. With the lever open, insert the hard disk drive assembly into the chassis, then push in the lever to lock it into place (see letter "F"). Figure 28. Installing Hard Disk Drive - Inserting 2.5" HDD assembly Replacing the Power Supply Caution: The power supply is only hot-swappable if you have a redundant system with two power supplies installed. If you only have one power supply installed, before removing or replacing the power supply, you must first take the system out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the power cord from the system or wall outlet. The power supply can be replaced if it fails. To replace the power supply, follow these steps: 1. Do one of the following: - If a filler panel is installed, use the 'finger hole' to remove the filler panel (see letter "A"). Figure 29. Removing the filler panel - If a power supply is installed, push the green latch in the direction shown while pulling the power supply out of the system by the handle. 16 Intel® JBOD 2U System Service Guide