Intel JBOD2000 Intel Storage System JBOD2000 Family Service Guide - Page 29

Hardware Installations and Upgrades Figure 39. Installing 3.5" hard drive backplane - install the hard drive cage 6. Intall the clip to server chassis (see letter "F"). 7. With the lever open, insert the hard disk drive assembly into the chassis (see letter "G"). Push in the lever to lock it into place (see letter "H"). Repeat step G and H to make sure all hard drive assemblies are in place. Figure 40. Installing 3.5" hard drive backplane - install the stiffener and hard drives 8. Connect cables to the backplane. Please refer to "Cable Routing". Replacing the 2.5" Hard Drive Backplane Removing the 2.5" Hard Drive Backplane: 1. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed in the carrier. Disconnect all cables from the backplane. 2. Remove the six screws to release the stiffener (see letter "A"). 3. Slide the stiffener cage out of the server chassis (see letter "B"). Intel® JBOD 2U System Service Guide 21