Intel S845WD1-E Product Guide - Page 14
Intel 845E Chipset, Intel 82845E Memory Controller Hub (MCH) - ram
UPC - 735858159272
View all Intel S845WD1-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
DIMM and memory configurations must adhere to the following: • 2.5 V (only) 184-pin DDR SDRAM DIMMs with gold-plated contacts • Unbuffered single-sided or double-sided DIMMs. • Maximum total system memory: 2 GB; Minimum total system memory: 64 MB • 200/266 MHz DDR SDRAM DIMMs only • Serial Presence Detect (SPD) • Suspend to RAM • Non-ECC and ECC DIMMs • Only DIMMs tested and qualified by Intel or a designated memory test vendor will be supported on the S845WD1H server board. A list of qualified DIMMs will be made available. Note that all DIMMs are supported by design, but only fully qualified DIMMs will be supported. Intel 845E Chipset The Intel 845E chipset consists of the following devices: • Intel 82845E Memory Controller Hub (MCH) with Accelerated Hub Architecture (AHA) bus • Intel 82801BA I/O Controller Hub (ICH2) with AHA bus • Intel 82802AB Firmware Hub (FWH) The MCH is a centralized controller for the system bus, the memory bus, the AGP bus, and the Accelerated Hub Architecture interface. The ICH2 is a centralized controller for the board's I/O paths. The FWH provides the nonvolatile storage of the BIOS. Intel 82845E Memory Controller Hub (MCH) The MCH supports the data integrity features supported by the Pentium Pro bus, including address, request, and response parity. The 845E chipset always generates ECC data while it is driving the processor data bus, although the data bus ECC can be disabled or enabled by BIOS. It is enabled by default. The MCH provides the following: • An integrated Synchronous DRAM memory controller with auto detection of SDRAM. • Support for ACPI Rev 1.0b compliant power management. 14 Intel Server Board S845WD1-E (S845WD1H) Product Guide