Intel SRCU42L User Guide - Page 15
Changing Jumper Settings - motherboard
UPC - 735858157872
View all Intel SRCU42L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Hardware Installation Figure 2-2. Installing the IIR Controller into a Computer System PCI 2.1.3 Changing Jumper Settings The IIR controller normally comes ready to be installed into the computer motherboard immediately. However, jumper settings are available to: • Reprogram the RAID firmware that is located in the flash memory of the IIR controller. • Change the configuration for SCSI power and/or termination. The board contains 3 jumper blocks to control the functions described in Table 2-1. See Figure 2-3 for jumper locations and pin numbers, and see Appendix A for a detailed description of jumper J4. Hardware Installation and User's Guide 15
Hardware Installation and User
’
s Guide
15
Hardware Installation
Figure 2-2. Installing the IIR Controller into a Computer System
2.1.3
Changing Jumper Settings
The IIR controller normally comes ready to be installed into the computer motherboard
immediately. However, jumper settings are available to:
•
Reprogram the RAID firmware that is located in the flash memory of the IIR controller.
•
Change the configuration for SCSI power and/or termination.
The board contains 3 jumper blocks to control the functions described in
Table 2-1
. See
Figure 2-3 for jumper locations and pin numbers, and see
Appendix A
for a detailed
description of jumper J4.
PCI