Intel SRCU42L User Guide - Page 18
Silencing the Audible Alarm in StorCon
UPC - 735858157872
View all Intel SRCU42L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Hardware Installation 2.2.1 LED Indicators The LEDs on the controller indicate SCSI activity, data transfer, power status, PCI bus frequency, and reset mode. Figure 2-4. LED Labels and Colors A B T S P P66 green green red green yellow yellow Table 2-2. LED Descriptions LED Description A Indicates SCSI activity on channel A. B Indicates SCSI activity on channel B. T Indicates data transfer to the controller's cache memory. S When illuminated, the controller's IOP is in reset mode. See J4 in Section 2.1.3, Changing Jumper Settings. P When illuminated, the controller is powered on. P66 When illuminated, PCI bus frequency is 66Mhz. When not illuminated, PCI bus frequency is 33Mhz. 2.2.2 2.2.2.1 Audible Alarm An 80db audible alarm, which is controlled by the RAID firmware, is mounted on the RAID controller to indicate any of the following events: • State of controller upon boot-up • Change in the normal state of the array • Change of controller environmental status (during normal operation) • Failure of hardware that the controller manages If the cause of the event is resolved and/or removed, the audible alarm will cease. You can also turn off the audible alarm manually through StorCon or StorCon+. If you use these management tools to silence the alarm, it will only be disabled for the current event and will be ready to sound again at the next event. Silencing the Audible Alarm in StorCon In StorCon, under Advanced Setup > Configure Controller, press to silence alarm. Note: The option is only available if the alarm has been activated. 18 Hardware Installation and User's Guide