Invacare IH6077A/IH61 Owners Manual - Page 23
Replacing the Recline Mechanism Guard
View all Invacare IH6077A/IH61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
1. Recline the recliner to raise the footrest assembly. Refer to Reclining the Chair on page 15. 2. Remove the four hex screws that secure the existing footrest cushion to the recline mechanism. 3. Align the four mounting holes of the recline mechanism with the four mounting holes of the new footrest cushion. 4. Using four hex screws, secure the footrest cushion to the recline mechanism. SECTION 5-MAINTENANCE Footrest Cushion Footrest Assembly Recline Hex Screws Mechanism FIGURE 5.3 Replacing the Footrest Cushion Replacing the Recline Mechanism Guard NOTE: For this procedure, refer to FIGURE 5.4 on page 24. NOTE: Right and left sides are determined from the userʹs seated position. 1. Engage wheel locks. 2. Carefully tip recliner onto the right side. Be sure there are no obstructions on or around the floor before doing this. 3. Remove the side panel. Refer to Removing/Installing the Side Panel on page 28. 4. Remove four existing bolts A, B, C, and D from side frame as shown in FIGURE 5.4 on page 24. 5. Remove existing recline mechanism guard. 6. Position new recline mechanism guard against the side frame with the folded edge down. 7. Align holes of new recline mechanism guard with holes on side frame. 8. Secure new recline mechanism guard to side frame with bolts A, B, C, and D. Securely tighten. 9. Install the side panel. Refer to Removing/Installing the Side Panel on page 28. 10. Place chair in the upright position. NOTE: If binding or pinching of recline mechanism guard occurs, contact Invacare. 11. Carefully tip recliner onto the left side. Ensure there are no obstructions on or around the floor before doing this. 12. Repeat STEPS 3‐10 to install remaining recline mechanism guard. Part No. 1141494 23 Invacare Mobile Recliners