Invacare IH6077A/IH61 Owners Manual - Page 24
Replacing the Elbow Pads - Model IH6077A Only, Adjusting Gas Spring Recline Cylinder Assembly, Model
View all Invacare IH6077A/IH61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
SECTION 5-MAINTENANCE Side View Rear of Chair Seat Cushion Front of Chair Side Frame DO NOT Remove This Bolt Footrest Bolt A Bolt B Bolt C Bolt D Recline Mechanism Guard FIGURE 5.4 Replacing the Recline Mechanism Guard Replacing the Elbow Pads - Model IH6077A Only NOTE: For this procedure, refer to FIGURE 5.5. 1. Remove two hex head screws that secure the existing elbow pad to the elbow pad bracket. 2. Remove existing elbow pad and discard. 3. Using the existing hex head screws, secure the new elbow pad to the elbow pad bracket. Elbow Pad Elbow Pad Bracket Hex Head Screws FIGURE 5.5 Replacing the Elbow Pads Model IH6077A Only Adjusting Gas Spring Recline Cylinder Assembly Model IH6077A Only NOTE: For this procedure, refer to FIGURE 5.6 on page 25. 1. Remove the mounting screw which secures the cable to the back assembly. 2. Remove the retaining ring from the clevis pin. 3. Remove mounting bolt and locknut securing the gas spring recline cylinder to the back frame. 4. Recline the back until cylinder can be removed from mounting bracket easily (approximately a 45° angle). 5. Remove gas spring recline cylinder. 6. Loosen the locknut on the bottom of the cylinder (Detail ʺAʺ). 7. Hold the bottom bracket and turn the cylinder until cable becomes taut. NOTE: If the cylinder was not locking when the lever was actuated, turn cylinder clockwise. If the cylinder was not locking when the lever was released, turn cylinder counterclockwise. Invacare Mobile Recliners 24 Part No. 1141494