JVC DT-V1900CGU Instruction Manual - Page 26

SPECIFICATIONS (cont'd) Ⅵ Compliant Signal Formats of Each Input Card Input Signals NTSC (3.58 MHz) PAL (4.43 MHz) Black-and-White (50 Hz/60 Hz) 480/60i (525i) 480/60p (525p) 576/50i 576/50p 720/60p (720p) 1080/50i 1080/60i (1125i) 1035/60i (1125i) (*1) 1080/24psF EMBEDDED AUDIO IF-C01PNG R R R IF-C01COMG - - - R R R R R R R ⅜ R - R : Input possible. Pre-set. ⅜ : Input possible. Not pre-set. - : Input impossible IF-C01SDG - - - R - R IF-C01HSDG R R R ⅜ R - *1 : 1035/60i (1125i) is not pre-set. To input signals of these types, some setup adjustments are required. IF-C12HSDG R R R ⅜ R R APPENDIX: CONNECTION EXAMPLES FOR THE SDI/HD SDI INPUT CARD (IF-C01SDG/ IF-C01HSDG only) This section explains the usage precautions and connection examples when using the SWITCHED OUT terminal of the SDI/HD SDI input card. Usage Precautions ● The selected signal is output from the SWITCHED OUT terminal only when the monitor's power is turned on. ● The output signal from the SWITCHED OUT terminal is the one that is selected from the signals input to SDI 1/HD SDI 1 or SDI 2/HD SDI 2. The table below shows the connection between the INPUT SELECT buttons (input signal selection) and the input/output of the SDI/HD SDI input card. Selected INPUT SELECT Buttons A, C, E B, D, F Signal Output from the SWITCHED OUT Terminal Signal from SDI 1/HD SDI 1 Signal from SDI 2/HD SDI 2 26 LCT1117-001C 26 02.6.6, 11:39 AM