JVC GC FM1 Detailed User Guide - Page 23

Warning Indications Before requesting service, consult the following chart. If the solutions indicated in the chart do not solve the problem, consult your nearest JVC dealer or JVC service center for instructions. Refer also to the FAQ section on JVC's website The following phenomena are not malfunctions. • LCD monitor momentarily become red or black when sunlight is recorded. • Black spots, or red, green, or blue spots appear on the LCD monitor. (The LCD monitor contains 99.99% effective pixels, but 0.01% or fewer pixels may be ineffective.) The camera is a microcomputer-controlled device. Electrostatic discharge, external noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such a case, reset the camera. 88To Reset the Camcorder If the camcorder malfunctions, push into the reset hole with a pointed object such as a wire to initialize the camcorder. (Z p. 5) Indication Memory card is full Internal memory is full Memory card is protected Action • Delete files or move them to a computer or other storage. • Replace the SD card with a new one. • Unlock the write-protect switch of the SD card. Z 10, 16, 18 - Memory card is low speed Memory card cannot be used No Files Invalid This file is protected Insufficient battery. Please charge it. Format failed. Recovery failed. Delete failed. The file number reaches a maximum. Please delete all files in the memory card or the internal memory for recording. • Replace the SD card with specifications one that is compatible with high-speed transfer. • Format the SD card. • Replace the SD card with a new one. • Remove the SD card and check whether the data on the SD card was recorded using this camcorder. • Deletion cannot be performed on the camcorder. Cancel the protection on a computer and then delete the file. • Recharge the battery. • Make sure that you used the correct procedure and try again. • Turn off the camcorder and then turn on again. • If the actions above do not resolve the issue, replace the SD card with a new one. • Move files to a computer, and then format the SD card. • Replace the SD card with a new one. • Make sure that you used the correct procedure and try again. • If the actions above do not resolve the issue, replace the SD card with a new one. • Delete all files. • Replace the SD card with a new one. 10 10, 13 - - 9 10 13 10, 13, 18 13, 16 10, 16 23