JVC GD-V422UA Instruction Manual - Page 46

Accessories Accessories Supply Check that you have the accessories and items shown Operating Instruction book GD-V422PCE GD-V502PCE Remote Control Transmitter EUR646532 INPUT SURROUND VOL N R PICTURE SOUND SET UP MULTI ZOOM PIP SWAP SELECT MOVE PICTURE POS. /SIZE ASPECT PC OFF TIMER PLASMA DISPLAY Batteries for the Remote Control Transmitter (2 × R6 Size) Fixing bands AC cord AC cord (For UK only) Ferrite core (small size) × 1 Ferrite core (large size) × 2 Remote Control Batteries Requires two R6 batteries. 1. Turn the transmitter face down. Press and slide off the battery cover. 2. Install the batteries as shown in the battery compartment. (Polarity + or - must match the markings in the compartment.) 3. Replace the cover and slide in reverse until the lock snaps. Two "R6" size Helpful Hint: For frequent remote control users, replace old batteries with Alkaline batteries for longer life. Precaution on battery use Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter. Observe the following precaution: 1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set. 2. Do not combine a used battery with a new one. 3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"). 4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display. 6