JVC GD-V422UA Instruction Manual - Page 64

Screensaver (For preventing after-images) Do not display a still picture, especially in 4:3 mode, for any length of time. If the display must remain on, a Screensaver should be used. 1 SET UP Press to display the Setup menu screen. 2 Press to select the Screensaver. Press to select the Screensaver screen. Setup 1/2 Component/RGB-in select RGB Input label RGB1 Signal Screensaver Power save Off Standby save On Power management Off OSD Language English (UK) Reversal / Scroll selection 3 Press to select the Function. Press to select the desired function. White bar scroll Image Reversal Screensaver Start Function Mode Start Time Finish Time Side panel Wobbling Peak limit PRESENT TIME 10 : 00 White bar scroll Off 0 : 00 0 : 00 High Off Off White bar scroll : The white bar will scroll from left to right. Image Reversal : Negative image will be displayed on the screen. Mode selection 4 Press to select the Mode. Press to select each mode items. Off Screensaver Start Function Mode Start Time Finish Time Side panel Wobbling Peak limit PRESENT TIME 10 : 00 White bar scroll Off 0 : 00 0 : 00 High Off Off Start setting 5 Interval : Operates when Periodic Time and Operating Time are setup and those times arrive. Time Designation : Operates when Start Time and Finish Time are setup and those times arrive. On : Operates when Start is selected and the (ACTION) is pressed. Screensaver When the Mode is set to On, press to select Start. Start Function Mode Start Time Finish Time Side panel Wobbling Peak limit PRESENT TIME 10 : 00 White bar scroll On 0 : 00 0 : 00 High Off Off Press to start Screensaver. The menu screen will disappear and the Screensaver will be activated. To stop the Screensaver under On, press the R button. Note: This function does not guarantee the complete prevention of permanent after-images. The potential for the occurrence of permanent after-images is merely decreased. 24