JVC GR-DVM50U Instruction Manual - Page 17

START/STOP Button Tape remaining time indicator 25 min min (Now calculating) 90 min 89 min 3 min 2 min (Blinking) 1 min (Blinking) 0 min (Blinking) EN17 4 STOP RECORDING Press START/STOP again to stop recording. •The camcorder re-enters the Record-Standby mode. NOTES: ● The image will not appear simultaneously in the LCD monitor and the viewfinder. No image appears on the LCD monitor when the viewfinder is pulled out. It is not possible to shoot using both LCD monitor and viewfinder. ● The cassette holder cannot be opened unless a power supply is attached. ● There may be a delay after you open the cassette cover until the holder opens. Do not use force. ● The indicated tape remaining time is approximate. ● The time required to calculate and to display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used. ● "TAPE END" appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. "TAPE END" also appears when a cassette whose tape is already at its end is loaded. ● If the Record-Standby mode continues for 5 minutes, the camcorder's power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor. ● When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. Continue recording from where you stop so that there are no gaps by following "Recording from the middle of a tape" (੬ pg. 21). ● During recording, sound is not heard from the speaker. If you want to hear the sound, connect optional headphones to the headphones connector. The sound volume at this point is the same as the level it was adjusted during playback. ● To turn the tally lamp off during recording, refer to pgs. 28 and 30. RECORDING