JVC GR-DVM50U Instruction Manual - Page 30

30 EN RECORDING Advanced Features (cont.) Date/Time Menu Explanations INDICATION ON OFF Makes all the indications appear in the camcorder (੬ pg. 23). Keeps all the indications (except the tape running indicator, warnings, etc.) from appearing in the camcorder (੬ pg. 23). ON SCREEN OFF Keeps the camcorder's display from appearing on the connected TV screen. DISPLAY DATE/TIME ON Makes the camcorder's display appear on screen when the camcorder is connected to a TV. ON Makes the date/time settings appear in the camcorder (੬ pg. 22). OFF Keeps the date/time settings from appearing in the camcorder. Allows you to set the current date and time (੬ pg. 10). System Menu Explanations TELE MACRO SCENE BEEP/TALLY WIND CUT SOUND MODE ID NUMBER DEMO. MODE OFF ON 5S 5SD Usually the distance to a subject where the lens is in focus depends on the zoom magnification. Unless there is a distance more than 1m (3.3 ft.) to the subject, the lens is out of focus at the maximum telephoto setting. When set to "ON", you can shoot a subject as large as possible at a distance of approx. 60 cm (2 ft.). • Depending on the zoom position, the lens may go out of focus. ੬ pg. 24. ੬ pg. 24. ANIM. Allows you to record a 1/3-second clip. By using an inanimate object and changing its position between shots, you can record the subject as though it is moving (੬ pg. 24). ON The tally lamp comes on to signal the start of recording. The beep sounds when the power is turned on or off, and at the beginning and end of recording. Also to activate the shutter sound effect (੬ pg. 26). OFF The tally lamp remains off at all times. Even though not heard while shooting, shutter sound is recorded on the tape. OFF Disengages the function which cuts down on noise created by wind. ON Helps cut down on noise created by wind. • " " appears. • The quality of the sound will change. This is normal. 32 kHz Enables recording of stereo sound on four separate channels, and is recommended for use when performing audio dubbing. 48 kHz Enables recording of stereo sound on two separate channels. This number is necessary when connecting the camcorder to a device such as a computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06. OFF ON Automatic demonstration will not take place. Demonstrates certain functions such as Program AE with special effects, etc., and can be used to confirm how these functions operate. When "DEMO. MODE" is set to "ON" and the Recording Menu is closed, demonstration starts. NOTES: ● If a tape is in the camcorder, the demonstration cannot be turned on. ● By turning off the camcorder, "DEMO. MODE" is set to "OFF" automatically. : Factory-preset