JVC KW-V51BT Instruction Manual - Page 46
Installing/removing the unit
View all JVC KW-V51BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
CONNECTION/INSTALLATION R Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5 Take Connector A on the wiring harness and connect it to the external power connector in your vehicle. 6 Connect the wiring harness connector to the unit. 7 Install the unit in your car. 8 Reconnect the · battery. 9 Press the reset button. 10 Configure . (Page 4) Installing/removing the unit R Installing the unit • Bend the tabs of the mounting sleeve with a 2 Remove the upper two locations. screwdriver or similar utensil and attach it in place. R Installing the trim plate Attach the trim plate (2). 2 R Removing the trim plate 1 Engage the catch pins on the extraction key (4) and remove the two locks on the lower part. Lower the frame and pull it forward. • The frame can be removed from the top side in the same manner. R Removing the unit 1 Remove the trim plate. (See the left column.) 2 Insert the two extraction keys (4), then pull them as illustrated so tat the unit can be removed. 4 • Be careful to avoid injury from the catch pins on 4 the extraction key. 46