JVC KY-F70BU Instruction Manual - Page 21

Mounting the lens Follow the procedure shown below when mounting an auto-iris lens. For further details, see the instruction manual of the lens and lens remote control. CAUTION • Perform mounting of the lens with the power of the camera turned OFF. Mounting with the power on could result in damage. 4mm or less • Lens is not included with this unit. To avoid damaging the main unit, make sure that the lens mount of the lens to be used is 4mm or less. Lens Camera head 3. Lock Male Thread section Mount clamp ring Lens 2. Compatible C-MOUNT DIGITALCAMERA KY-F70B 4. Lock Female zoom lens FUJINON S14×7.3DA-D24 Lens remote control Compatible lens remote control FJINON, RMD-10, RMD-20 1. Remove the lens mount cap. At this time, take caution so that dust do not enter inside the mount. 2. To mount the lens, lightly press the thread section of the lens mount onto the thread section of the main unit, then turn the mount clamp ring slowly clockwise until it is securely tight- ened. MEMO To change the position of the lens rotation: ቢ First, turn the mount clamp ring counterclockwise (1/4 turns) with the lens facing you. ባ Slowly turn the lens and after adjusting the position, retighten the mount clamp ring. 3. Insert the camera cable of the lens into the lens connection terminal on the rear of the main unit, then securely lock. The iris control is made automatically from the camera. When using a manual iris lens, set the IRIS MODE to MANUAL ( ੬ page 50). 4. When using the lens remote control, connect the lens control cable (female) to the remote control. When operating the lens iris manually by lens remote control connection, set IRIS MODE to manual. ( ੬ page 50) E17